Outback VDC Wagon AWD F6-3.0L (2002)
1 of 2
2 of 2
4. Suspend thread from wheel arch (point "A" in figure) to determine a point directly above center of wheel.
5. Measure distance between measuring point "A" and center of wheel.
2. CAMBER
^
Inspection
1. Place front wheel on turning radius gauge. Make sure ground contacting surfaces of front and rear wheels are set at the same height.
2. Set ST into the center of the wheel, and then install the wheel alignment gauge.
ST 927380002 ADAPTER
3. Follow the wheel alignment gauge operation manual to measure the camber angle.