SVX AWD L6-3.3L DOHC (1995)
1. Using hub stand, press new hub bolt into place.
a. Ensure hub bolt closely contacts hub.
b. Use a 12 mm (0.42 inch) hole in the hub stand to prevent hub bolt from tilting during installation.
2. Remove foreign particles (dust, rust, etc.) from mating surfaces of hub and tone wheel, and install tone wheel to hub.
a. Ensure tone wheel closely contacts hub.
b. Be careful not to damage tone wheel teeth.
3. Clean housing interior completely. Using housing stand "REAR" and bearing, press bearing into housing.
a. Always press outer race when installing bearing.
b. Be careful not to remove plastic lock from inner race when installing bearing.
c. Charge bearing with new grease when outer race is not removed.
4. Install snap ring. Ensure snap ring fits in groove properly.
