Tribeca F6-3.6L (2008)
2. Remove the scuff plate outer.
5. CENTER PILLAR LOWER TRIM
1. Remove the front door scuff plate.
2. Remove the rear door scuff plate.
3. Remove the clip, and remove the center pillar lower trim.
6. CENTER PILLAR UPPER TRIM
1. When removing the parts of passenger's side, disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
2. Remove the front door scuff plate.
3. Remove the rear door scuff plate.
4. Remove the center pillar lower trim.
5. Turn over the floor mat to remove the seat belt lower anchor bolt.
6. Disconnect the connector of belt tension sensor on passenger's side.
