Tribeca F6-3.6L (2008)
Brake Caliper: Removal and Replacement
Front
Front Disc Brake Assembly
REMOVAL
CAUTION: Do not allow brake fluid to come in contact with vehicle body. If it does, wash off with water and wipe away completely.
1) Lift up the vehicle, and remove the front wheels.
2) Remove the union bolt, and disconnect the brake hose from the caliper body assembly.
3) Remove the bolt securing the lock pin to caliper body.
4) Raise the caliper body, and then move it toward vehicle center to separate it from the support.
5) Remove the support from housing.
NOTE: Remove the support only when replacing the rotor or support. It need not be removed when servicing the caliper body assembly.
6) Remove mud and foreign matter from the caliper body assembly and support.
INSTALLATION
1) Apply a thin coat of Molykote M7439 (Part No. K0770YA000) to the support.
