Tribeca F6-3.6L (2008)
Brake Hose/Line: Service and Repair
Brake Pipe
Brake Pipe
REMOVAL
NOTE: The airbag system wiring harness is routed near the center brake pipe.
CAUTION:
^
All airbag system wiring harness and connectors are colored yellow. Do not use the electrical test equipment on these circuits.
^
Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^
When removing the brake pipe, do not bend.
INSTALLATION
NOTE: The airbag system wiring harness is routed near the center brake pipe.
CAUTION:
^
All airbag system wiring harness and connectors are colored yellow. Do not use the electrical test equipment on these circuits.
^
Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
^
When installing the brake pipe, do not bend.
^
After installing the brake pipe and hose, perform air bleed.
^
After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
Brake pipe tightening torque: 15 N-m (1.5 kgf-m, 10.8 ft-lb)
INSPECTION
Make sure there are no cracks, breakage or damage on hoses. Check the joint for fluid leakage. If any cracks, breakage, damage or fluid leakage is
found, repair or replace the pipes.
NOTE: Use a mirror when inspecting back sides and other locations which are hard to see.
