Tribeca F6-3.6L (2008)
Evaporator Core: Service and Repair
Evaporator
REMOVAL
1. FRONT
1. Using the refrigerant recovery system, discharge refrigerant.
2. Disconnect the ground cable from the battery.
3. Remove the blower motor unit assembly.
4. Disconnect the connector, remove the screw and then remove the air-mix door actuator and mode door actuator.
5. Remove the bolts holding the expansion valve, and remove the expansion valve.
6. Remove the screws and pull out the evaporator.
7. Remove the pipe cover from the evaporator.
8. Remove the bolt which holds the pipe to evaporator, and remove the evaporator.