Tribeca F6-3.6L (2008)
ABS Light: Testing and Inspection
Warning Light Illumination Pattern
INSPECTION
1. When warning lights or indicator lights do not illuminate in accordance with this illumination pattern, there must be an electrical malfunction.
2. When warning lights or indicator lights remain constantly OFF, check the combination meter circuit or CAN communication circuit.
3. When ABS warning light does not go off, check the combination meter circuit.
4. When the VDC indicator light, VDC warning light and TCS OFF indicator light do not go off, check the combination meter circuit or CAN
communication circuit.
NOTE:
^
Even though the ABS warning light does not go off after 1.5 seconds from ABS warning light illumination, the ABS system operates normally
when the warning light goes off while driving at approximately 12 km/h (7 MPH). However, the ABS system does not work while the ABS
warning light is illuminated.
^
It may take several minutes before VDC warning light and TCS OFF indicator light goes off if the vehicle is parked under low temperature for
a specified time. This is not defective because it is resulted from low engine coolant temperature.
^
With the vehicle jack-up/lift-up or set on free rollers, when the wheels lock or spin after starting the engine, ABS warning light, VDC warning
light and TCS OFF indicator light may illuminate because VDCCM&H/U detects the abnormal conditions from ABS wheel speed sensors. In
this case, this is not a malfunction. Perform the clear memory mode.
