Tribeca F6-3.6L (2008)
Malfunction Indicator Lamp: Description and Operation
Activation Of Malfunction Indicator Light
1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the combination meter illuminates.
NOTE: If the malfunction indicator light does not illuminate, perform diagnostics of the malfunction indicator light circuit or the combination
meter circuit. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Symptom Related Diagnostic
Procedures/Malfunction Indicator Light Does Not Come On
2. After starting the engine, the malfunction indicator light goes out. If it does not go off, either the engine or emission control system has
malfunction.
3. Turn the ignition switch to OFF and connect the delivery (test) mode connector.
1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light illuminates.
2. After the engine starts, malfunction indicator light blinks in a cycle of 0.5 Hz. (During diagnosis)
3. Malfunction indicator light blinks at a cycle of 3 Hz after diagnosis if there is no trouble. Malfunction indicator light illuminates if faulty.
