Tribeca F6-3.6L (2008)
Headlamp Bulb: Testing and Inspection
Headlight Bulb
INSPECTION
1. HALOGEN TYPE
1. Visually check the bulb for blow out.
2. Check the bulb specification.
3. If NG, replace the bulb with a new part.
2. HID TYPE
CAUTION:
-
Do not perform work with wet hands.
-
When lit (lighting switch is ON), do not touch the harness, light internals, or metal parts of the light.
-
When performing a lighting check, always do so in a vehicle installed condition, and connect with the vehicle connector for the power
source.
1. Check the bulb specification.
2. Install the factory HID bulb to check whether it lights properly.
3. If it does not light properly, replace with a new bulb.
4. Inspect the HID ballast. Inspect the ballast in the following manner, and determine whether or not to reuse.
1. Perform cold starts (light the headlight after turning off for more than 10 minutes), and hot starts (light the headlight for 15 minutes or
more, then turn off for 1 minute and relight) several times, to make sure that the headlight lights properly.
2. Monitor the lighting condition right after a cold start up to a stable state (approx. 5 min.), to see if there are any unstable conditions such as
flickering.
3. Install bulbs with the same number of operating hours on both headlights, and light for approximately 30 minutes. Check for whether there
is a difference in brightness on the right and left sides.
5. If there is a problem, replace with a new ballast.
