Tribeca F6-3.6L (2008)
10. Remove the hose bracket and take out the hose assembly from vehicle.
INSTALLATION
1. Install in the reverse order of removal.
Tightening torque: <Ref. to COMPONENT.>
2. Fill with the specified fluid.
CAUTION: Never start the engine before feeding the fluid otherwise the vane pump might be seized.
3. Finally, check the clearance between pipes or hoses as shown in the figure indicated in General Diagnostic Table.
INSPECTION
Check all disassembled parts for wear, damage or other problems. Repair or replace the defective parts as necessary.
CAUTION: Although the surface layer materials of rubber hoses have excellent weathering resistance, heat resistance and resistance for low
temperature brittleness, they are likely to be damaged chemically by brake fluid, battery electrolyte, engine oil and automatic transmission fluid and
