Tribeca F6-3.6L (2008)
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from the battery.
3. Open the fuel filler flap lid, and remove the fuel filler cap.
4. Lift up the vehicle.
5. Disconnect the connector from fuel tank pressure sensor.
6. Disconnect the hose from the fuel tank pressure sensor.
7. Remove the fuel tank pressure sensor along with the bracket.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.4 N.m (0.75 kgf.m, 5.4 ft.lb)
