Tribeca F6-3.6L (2008)
Tightening torque:
85 N-m (8.7 kgf-m, 62.7 ft-lb)
18) Using the ST, crimp so that the diameter of punch hole is 2 - 2.5 mm (0.08 - 0.10 in) and is aligned to the position of 2 mm (0.08 in) from gearbox
cylinder end surface.
ST1 34099FA060 PUNCH HOLDER
ST2 34199XA050 BASE
19) Put a vinyl tape around the spline portion and apply genuine grease to the dust cover and install to valve assembly.
CAUTION:
Be sure to install the dust cover to groove of shaft.
20) Apply the genuine grease to the pinion gear and bearing of valve assembly.
