Tribeca F6-3.6L (2008)
Shift Interlock Solenoid: Service and Repair
Removal
AT Shift Lock Solenoid and "P" Range Switch
REMOVAL
NOTE:
For removal of the mode change switch and the shift button switch, refer to the section on Select Levers. See: Automatic
Transmission/Transaxle/Shifter A/T/Service and Repair/Removal and Replacement
"P" RANGE SWITCH
1) Remove the console box.
2) Disconnect the connector.
3) Remove the connector from the base plate using a flat-tip screwdriver.
4) Disconnect the terminal of "P" range switch from connector, using a flat-tip screwdriver with thin tip.
5) Remove the clip while being careful not to break the pin, then remove the P range switch.
AT SHIFT LOCK SOLENOID
1) Remove the console box.
2) Disconnect the connector.