Tribeca F6-3.6L (2008)
15) Tap the clip with the punch provided at the end of the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tap to an extent that the boot underneath is not damaged.
16) Cut off the band with an allowance of about 10 mm (0.39 in) left from the clip and bend this allowance over the clip.
NOTE:
Be careful so that the end of the band is in close contact with clip.
17) Install the EBJ boot using the same procedures as for the DOJ boot.
18) Extend and retract the DOJ repeatedly to provide an equal coating of grease.
Rear Drive Shaft Inspection
INSPECTION
Check the removed parts for damage, wear, corrosion etc. Repair or replace if defective.
^
DOJ (Double Offset Joint)
Check for seizure, corrosion, damage, wear and excessive play.
^
EBJ (high-efficiency compact ball fixed joint)
Check for seizure, corrosion, damage, wear and excessive play.
^
Shaft
Check for excessive bending, twisting, damage and wear.
^
Boot
Check for wear, warping, breakage and scratches.
^
Grease
Check for discoloration and fluidity.
