XT-6 2WD L6-2.7L SOHC (1989)
3.
Using an OHM meter, put both terminals to both poles of the limit switch and check for continuity. When depressing damper spring with pocket
screwdriver no continuity should be noted.
If the limit switch fails in the above test, it must be removed again and reinstalled. In case that the removal/installation is not successful or any
abnormalities exist even after replacing the limit switch with another one, replace the "rail & motor assembly."
4.
Reinstall trim panels and reconnect negative battery cable.
The parts listed below can also be found in Parts Catalog No. EBU8-01, Figure 646-1B, pages 664-666, detail F.
Part Number
Part Name
Quantity
64957GA090
Limit Switch
1
64957GA120
Limit Switch
Cover RH
1
64957GA130
Limit Switch
Cover LH
1
64957GA150
Screw M3K
2
For warranty information refer to the 1990 Flat Rate Manual page 8A- 24-25.