XT-6 4WD L6-2.7L SOHC (1988)
Oxygen Sensor: Technical Service Bulletins
Oxygen Sensor - Special Tool Modification
NUMBER
14-10-88
DATE
01-25-88
1988 CALIFORNIA SPECIFICATION TURBO VEHICLES
SUBJECT:
SPECIAL TOOL ADAPTATION FOR TITANIA
O2 SENSOR REMOVAL
FIGURE 1
A Titania O2 Sensor is used on 1988 California Specification Turbo vehicles. Because of the size of the 3 wire connector, the O2 Sensor wrench
499990110 cannot be used without modification.
To modify the existing wrench by cutting a slit in the socket at the handle side as outlined below, see figure 1. This will eliminate the need for a separate
special tool.
