Aerio L4-2.3L (2006)
7. Install wheel and tighten wheel nuts to specified torque.
Tightening torque
(a): 85 Nm (8.5 kgf-m, 61.5 ft. lbs.)
8. Check to ensure that brake drum is free from dragging and proper braking is obtained. Then remove vehicle from hoist and perform brake test
(foot brake and parking brake).
Inspection
Brake Drum
Inspect brake drum for wear.
If limit value of drum inner diameter is exceeded or uneven or stepped wear is excessive, replace drum.
Drum inner diameter "a"
Standard: 200 mm (7.87 inch)
Limit: 202 mm (7.95 inch)
Cracked, Scored or Grooved Drum
A cracked drum is unsafe for further service and must be replaced. Do not attempt to weld a cracked drum.
Smooth up any slight scores. Heavy or extensive scoring will cause excessive brake lining wear and it will probably be necessary to resurface drum
braking surface.
If brake linings are slightly worn and drum is grooved, drum should be polished with fine emery cloth but should not be turned.
NOTE: When drum is removed, visually inspect wheel cylinder for brake fluid leakage. Correct leaky point, if any.
Brake Shoe
Measure thickness of brake shoe (1). Also, check surface of lining for hardening, excessive wear and oil.
Brake shoe thickness (lining + shoe rim)
Standard: 6.1 mm (0.24 inch)
Limit: 2.6 mm (0.10 inch)
