Aerio L4-2.3L (2006)
Brake Hose/Line: Service and Repair
Front
Removal
1. Raise and support vehicle properly. Remove tire and wheel.
NOTE: This operation is not necessary when removing pipes connecting master cylinder.
2. Clean dirt and foreign material from both flexible hose end and pipe end fittings.
3. Remove brake flexible hose or pipe.
Installation
Reverse brake flexible hose installation procedure, noting the following.
^
Make sure that steering wheel is in straightforward position and flexible hose has not twist or kink.
^
Check to make sure that flexible hose doesn't contact any part of suspension, both in extreme right and extreme turn conditions. If it does at any
point, remove and correct. Fill and maintain brake fluid level in reservoir.
^
Bleed brake system.
^
Perform brake test and check installed part for fluid leakage.