Aerio L4-2.3L (2006)
Air Bag Control Module: Testing and Inspection
With Advanced Air Bag
SDM Inspection
SDM Inspection
Reference: SDM Removal and Installation:Advanced Air Bag
WARNING:
During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM).
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag before starting to work and observe every
precaution during work. Neglecting them may result in personal injury or inactivation of the air bag system when necessary.
CAUTION:
-
Do not connect a tester whatever type it may be.
-
Never repair or disassemble SDM.
-
If SDM has been dropped, it should be replaced.
If any faulty condition is found in the following checks, replace.
-
Check SDM and SDM plate for dents, cracks or deformation.
-
Check SDM connector for damage, cracks or lock mechanism.
-
Check SDM terminal for bend, corrosion or rust.
OCM Inspection
OCM Inspection
Reference: OCM Removal and Installation:Advanced Air Bag
WARNING: As Occupant Classification Module (OCM) consists of precision parts, be careful not to expose it to excessive shock.
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag before starting to work and observe every
precaution during work. Neglecting them may result in personal injury or inactivation of the air bag system when necessary.
CAUTION:
-
Do not connect a tester whatever type it may be.
-
Never repair or disassemble OCM.
If any faulty condition is found in the following checks, replace.
-
Check OCM connector for damage, cracks or lock mechanism.
-
Check OCM terminal for bend, corrosion or rust.