Aerio L4-2.3L (2006)
11. Apply power steering fluid to O-ring (1).
12. Install O-ring (1) to pump body.
13. Apply power steering fluid to sliding surface of pump cover and rotor.
14. Match the dowel pins (1) to the holes of the cover plate (2) as shown and install pump cover to pump body.
15. Gradually tighten pump cover bolts to specified torque.
NOTE: After installing pump cover (1), check to make sure that shaft can be turned by hand.
Tightening torque
Pump cover bolts (a): 28 Nm (2.8 kgf-m, 20.0 ft. lbs.)
16. Apply power steering fluid to O-ring of terminal switch.
