Aerio L4-2.3L (2006)
Clutch Slave Cylinder: Service and Repair
Removal and Installation
Clutch Operating Cylinder Removal and Installation
Removal
NOTE: Do not allow fluid to get on painted surfaces.
1. Clean around master cylinder reservoir cap and take out fluid with syringe or such.
2. Disconnect fluid hose (5) from operating cylinder by loosing union bolt (4).
3. Remove operating cylinder attaching bolts (2) and operating cylinder assembly (1).
Installation
For air bleeding of master cylinder alone, it must be removed from vehicle body.
(For procedures of removal and installation of master cylinder assembly and air bleeding, refer to "Clutch Pedal Inspection:".)
1. Apply small amount of grease to rod tip.
NOTE: Don't allow any grease to be on boot.
"A": Grease 99000-25010
2. Install clutch operating cylinder assembly (1) and tighten attaching bolts (2) to specified torque.
Tightening torque
Operating cylinder attaching bolts (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
