Aerio L4-2.3L (2006)
2. Remove piston (2) by blowing compressed air into bolt hole (1) where hose was connected, using care to prevent it from jumping out.
Reassembly
NOTE: Before installation, wash each part in specified brake fluid.
1. Apply brake fluid to piston assembly and inside of cylinder.
2. Install piston assembly (1) into cylinder. When inserting it, be careful not to cause damage to lip of piston cup (2).
3. Install boot and push rod.
Clutch Operating Cylinder Inspection
Clutch Operating Cylinder Inspection
Inspect all disassembled parts for wear or damage, and replace parts if necessary.
NOTE:
^
Wash disassembled parts with brake fluid.
^
Do not reuse piston assembly.
Inspect cylinder bore for scoring or corrosion. It is best to replace corroded cylinder. Corrosion can be identified as pits or excessive roughness.
NOTE: Polishing bore of cylinder with anything abrasive is prohibited, as damage to cylinder bore may occur.
Rinse cylinder in clean brake fluid. Shake excess rinsing fluid from cylinder. Do not use a cloth to dry cylinder, as lint from cloth cannot be kept away
from cylinder bore surfaces.
