Aerio AWD L4-2.0L (2003)
9.
Lower the vehicle. Remove the engine hook and mount it to the new P/S Bracket. Remove the four P/S Bracket mounting bolts and swap the old
P/S Bracket for the new one. Thread the four bolts in finger tight. Apply force against the P/S Bracket towards the front of the engine and tighten
bottom bolt first then the remaining three upper bolts. Torque the bolts to 25 N.m (18 lb-ft).
NOTE:
Be sure the bracket is pulled forward an equal amount at the top and bottom.
10.
Raise the vehicle and reinstall the Generator, the upper and the lower Generator mounting bolts. Torque the upper bolt to 23 Nm (16.5 lb-ft) and
the lower bolt to 50 Nm (36 lb-ft). Reinstall the Generator Cover (not shown). Torque the Cover bolts to 8 Nm (70 lb-in)
