Aerio AWD L4-2.0L (2003)
Air Bag(s) Arming and Disarming: Service and Repair
Disabling Air Bag System
1. Turn steering wheel so that vehicle's wheels (front tires) and pointing straight ahead.
2. Disconnect negative (-) cable at battery.
3. Turn ignition switch to "LOCK" position and remove key.
4. Remove "AIR BAG" fuse (2) from fuse box (1).
5. Disconnect Yellow connector (3) of contact coil and combination switch assembly as follows.
a. Release locking of lock slider (5).
b. After unlocked, disconnect connector.
6. In case of passenger air bag (inflator) module, pull out glove box while pushing its stopper from both right and left sides and disconnect Yellow
connector (4) of passenger air bag (inflator) module as follows.
a. Release locking of lock slider (5).
b. After unlocked, disconnect connector.
NOTE: With "AIR BAG" fuse removed and ignition switch ON, "AIR BAG" warning lamp will be ON. This is normal operation and does not indicate
air bag system malfunction.
Enabling Air Bag System
1. Confirm that battery negative (-) cable is disconnected.
2. Turn ignition switch to "LOCK" position and remove key.
3. Connect Yellow connector (1) of contact coil and combination switch assembly by pushing connector till clicks heard from it.
