Aerio AWD L4-2.0L (2003)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - ECU programming Verification
GENERAL
Section Title: General Information
TSB No. TS05 10056
Division: Automotive
Category: Technical
SUBJECT:
ELECTRONIC CONTROL UNIT (ECU) REPROGRAMMING VERIFICATION PROCEDURE USING THE SUZUKI SDS TOOL
MODEL(S):
ALL
YEAR:
1996
CONDITION:
To verify that the latest Pass-Thru calibration information is programmed into the on-board ECU if glove box reprogram label is not complete and
affixed to the glove box door.
NOTE:
ECU refers to ECMs, TCMs, or PCMs.
CAUSE:
N/A
CORRECTION:
Follow the verification process outlined below.
Always properly complete the reprogramming label and affix it to the glove box door after verifying or performing pass-thru reprogramming.
Please refer to the Module reprogramming using "SDS" training course on the website for more information.
PART(S) INFORMATION:
PC Software and Database Verification Process