Aerio AWD L4-2.0L (2003)
2) With painted mark (1) on stabilizer bar and end face of mount bushing (2) aligned, tighten mount bracket bolts to specified torque.
NOTE: If painted mark has gone, align the vehicle center and the center of stabilizer bar.
Tightening torque
Stabilizer bar mounting bracket bolts (a): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)
3) Tighten each nut to specified torque. When tightening, hold stud with wrench.
Tightening torque
Stabilizer joint nuts (b): 50 Nm (5.0 kgf-cm, 36.5 ft. lbs.)
Stabilizer link nuts (c): 23 Nm (2.3 kgf-cm, 17.0 ft. lbs.)
Front Stabilizer Bar and/or Bushing Check
Bar
Inspect for damage or deformation.
If defective, replace.
Bushing
