Aerio AWD L4-2.0L (2003)
9. Apply primer for molding along molding surface all around.
10. Apply adhesive (1) referring to figure.
NOTE:
-
Press glass (2) against fittings surface of body panel quickly after adhesive (1) is applied.
-
Use of rubber sucker grip is helpful to hold and carry glass after adhesive (1) is applied.
-
Perform steps 8) to 9) within 10 min. to ensure sufficient adhesion.
-
Be sure to refer to adhesive maker's instruction for proper handling and drying time.
-
Start from bottom side of glass (2).
-
Be careful not to damage primer.
Adhesive amount specifications and position for windshield
Width "a": Approx. 7 mm (0.27 in.)
Height "b": Approx. 15 mm (0.59 in.)
Position "c": Approx. 11 mm (0.43 in.) for front, rear and upper section
Position "d": Approx. 17 mm (0.67 in.) for bottom section
