Aerio AWD L4-2.0L (2003)
11. Holding rubber sucker grips (1), place glass onto body by aligning mating marks marked in step 3) and press it.
12. Check for water leakage by pouring water over windshield through hose. If leakage is found, dry windshield and fill leaky point with adhesive. If
water still leaks even after that, remove glass and start installation procedure all over again.
NOTE:
-
Do not use high pressure water.
-
Do not blow compressed air directly at adhesive applied part when drying.
-
Do not use infrared lamp or like for drying.
