Aerio AWD L4-2.0L (2003)
Wiper Switch: Testing and Inspection
Front Wiper and Washer Switch
Front Wiper and Washer Switch
Check for continuity between terminals at each switch position as shown in the figure. If check result is not as specified, replace.
Intermittent Wiper Relay Circuit
1. Turn the front wiper switch to "INT" position.
2. Connect battery positive terminal to terminal "B3" and its negative terminal to terminal "EW".
3. Connect voltmeter positive lead to terminal "L" and its negative lead to terminal "EW".
4. Check that the voltmeter indicates the battery voltage (10 - 14 V).
5. Connect terminal "AS" and terminal "B3" for 5 sec. or more by a jumper wire.
6. Disconnect end of the jumper wire from terminal "B3".
7. Connect disconnected jumper wire end to terminal "EW", then check that voltage between terminal "L" and terminal "EW" changes as shown in
figure.
If check result is not satisfied, replace.
