Equator 2WD V6-4.0L (2009)
Rear Door Window Regulator: Service and Repair
Rear Door Glass Regulator: On-Vehicle Repair
REMOVAL
1. Remove the rear door finisher. Refer to [Door Finisher: Removal and Installation].
2. Remove the inside seal.
3. If equipped, temporarily reconnect the power window switch.
4. For power windows, operate the power window switch to raise/lower the door window until the glass bolts can be seen.
5. For manual windows, temporarily reinstall the window crank handle and lower the window until the glass bolts can be seen.
6. Raise the rear door glass and hold it in place with suitable tool.
7. Remove the bolts and the regulator assembly.
-
If equipped, disconnect the connector from the regulator assembly.