Equator 2WD V6-4.0L (2009)
Lower Side Moulding / Trim: Service and Repair
Body Side Trim: Removal and Installation
Body Side Trim: Removal And Installation
LOWER DASH SIDE FINISHER
Removal
1. Remove push pin from lower dash side finisher.
2. Remove front kick plate from center pillar lower finisher.
3. Remove front kick plate from dash side from lower dash side finisher.
4. Remove lower dash side finisher.
Installation
Installation is in the reverse order of removal.
CENTER PILLAR LOWER FINISHER
Removal
1. Remove front and rear door welts.
2. Remove seat belt anchor. Refer to [LATCH (Lower Anchors and Tether for Children) System: Removal and Installation].
-
On RH side, remove the cover and disconnect seat belt tension sensor.
3. Remove front and rear kick plates.
4. Remove center pillar lower finisher.
Installation
Installation is in the reverse order of removal.
CENTER PILLAR UPPER FINISHER
Removal
1. Remove front and rear door welts.
2. Remove seat belt shoulder anchor and D-ring. Refer to [LATCH (Lower Anchors and Tether for Children) System: Removal and Installation].
3. Remove front and rear kick plates.
4. Remove center pillar lower finisher.
5. Remove assist grip.
6. Remove center pillar upper finisher.
Installation
Installation is in the reverse order of removal.
FRONT PILLAR UPPER FINISHER
Removal
1. Remove front pillar lower finisher.
2. Remove the front pillar assist grip.
3. Remove the front pillar upper finisher bolt.
4. Remove the front pillar upper finisher.
Installation
Installation is in the reverse order of removal.
FRONT PILLAR LOWER FINISHER
Removal
1. Remove front door welt and kick plate.