Equator 2WD V6-4.0L (2009)
Installation
-
On vehicles coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No. 4210 or equivalent, after priming with 3M primer
Product No. N200, C-100 or equivalent.
-
The repair parts are also affixed with double-faced adhesive tape.
-
To re-use existing molding, clean all traces of double sided tape from the molding and apply new double-faced tape to the molding.
1. Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
2. Heat the panel and molding tape surface to 30° to 40° C (86° to 104° F).
3. Remove the backing sheet from the tape surface.
-
Align the locating pin into the hole in the outer door.
-
Continue aligning the pins into their corresponding holes in the outer door during installation.
4. Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press molding to door surface.
-
Apply even pressure along molding to insure proper wet out.
CAUTION: To secure contact, do not wash vehicle for 24 hours after installation.