Equator 2WD V6-4.0L (2009)
1. Disconnect the negative and positive battery terminals, then wait at least 3 minutes.
2. Remove body side trim panels. Refer to [Body Side Trim: Component].
3. Remove rear trim. Refer to [Headlining: Removal and Installation].
4. Remove sun visor assemblies, both LH and RH.
5. Remove sun visor holders LH and RH.
6. Remove roof console (if equipped).
-
Disconnect harness.
7. Remove room lamp.
-
Disconnect harness.
8. Remove striker covers (King Cab only).
9. Remove assist grips.
10. Remove rear window glass (Crew Cab only). Refer to [Rear Window Glass and Molding: Removal and Installation].
11. Remove headlining.
NOTE: Use an assistant to steady the headlining while lowering from roof.
-
Remove clips from center of headlining (if equipped).
-
Remove headlining by tilting through rear window opening on Crew Cab models.
12. Remove assist grip brackets from roof.
INSTALLATION
Installation is in the reverse order of removal.
