Equator 2WD V6-4.0L (2009)
WARNING:
Clean dust on caliper and brake pad with a vacuum dust collector to minimize the hazard of airborne particles or other materials.
CAUTION:
^
While removing brake pads never depress brake pedal because piston will pop out.
^
It is not necessary to remove bolts on torque member and brake hose except for disassembly or replacement of caliper body. In this
case, hang caliper body with a wire so as not to stretch the brake hose.
^
Do not damage the piston boot.
^
If any shim is subject to serious corrosion, replace it with a new one.
^
Always replace inner and outer shims as a set when replacing brake pads.
^
Keep rotor free from brake fluid.
^
Burnish the brake contact surface after refinishing or replacing rotors, after replacing pads, or if a soft pedal occurs at very low
mileage.
Rear Brake Pad: Removal and Installation
Rear Brake Pad: Removal and Installation
REMOVAL
1) Remove the rear wheel and tire.
