Equator 2WD V6-4.0L (2009)
CAUTION:
When attaching pad retainer, attach it firmly so that it is flush with torque member, as shown.
4) Using a suitable tool push piston into caliper body.
CAUTION:
By pushing in piston, brake fluid returns to master cylinder reservoir tank. Watch the level of the surface of reservoir tank.
NOTE:
Use a suitable tool to make it easier to push the piston into the caliper body.
5) Remove the suitable wire then swing the caliper body down over the brake pad assemblies.
6) Install the lower sliding pin bolt and tighten to 26.48 N-m (2.7 kg-m, 20 ft-lb).
7) Check the brakes for drag.
8) Inspect the brake fluid level, then install the master cylinder reservoir cap.
9) Install the rear wheel and tire.