Equator 2WD V6-4.0L (2009)
^
While removing caliper body never depress brake pedal because piston will pop out.
^
It is not necessary to remove bolts on torque member and brake hose except for disassembly or replacement of caliper body. In this case, hang
caliper body with a wire so as not to stretch the brake hose.
^
Do not damage the piston boot.
^
If any shim is subject to serious corrosion, replace with a new one.
^
Always replace shim and shim cover as a set when replacing brake pads.
^
Keep rotor free from brake fluid.
^
Burnish the brake contact surface after refinishing or replacing rotors, after replacing pads, or if a soft pedal occurs at very low mileage.
Front Brake Caliper and Disc Rotor: Removal and Installation
Front Brake Caliper and Disc Rotor: Removal and Installation
REMOVAL
1) Remove the front wheel and tire.
2) Drain the brake fluid.
CAUTION:
^
Refill with new brake fluid.
^
Do not reuse drained brake fluid.
3) Remove the union bolt then disconnect the brake hose and discard the copper washers.
CAUTION:
Discard the copper washers, do not reuse.
4) Remove the sliding pin bolts and remove the caliper body from the torque member.
