Equator 2WD V6-4.0L (2009)
CAUTION:
^
All hoses and piping (tubes) must be free from excessive bending, twisting and pulling.
^
Make sure there is no interference with other parts when turning steering both clockwise and counterclockwise.
^
The brake piping is an important safety part. If a brake fluid leak is detected, always disassemble the parts. Replace applicable part
with a new one, if necessary.
^
Be careful not to splash brake fluid on painted areas; it way cause paint damage. If brake fluid is splashed on painted areas, wash it
away with water immediately.
^
Do not bend or twist brake hose sharply, or strongly pull it.
^
When removing components, cover connections so that no dirt, dust, or other foreign matter gets in.
^
Do not reuse drained brake fluid.
^
After installation of the ABS actuator and electric unit (control unit), refill brake system with new brake fluid. Then bleed the air
from the system.
Type 3 (HDC/HAS/VDC/TCS/ABS)
Brake Tube and Hose: Hydraulic Circuit
