Equator 2WD V6-4.0L (2009)
b) Apply liquid gasket (b) to the figure (a) squarely.
2) Install new rocker cover gasket to rocker cover.
3) Install rocker cover.
^
Check to be sure rocker cover gasket is not dropped from installation groove of rocker cover.
4) Tighten the rocker cover bolts in two steps in numerical order as shown.
1st step :1.96 Nm (0.20 kg-m, 17 in-lb)
2nd step :8.33 Nm (0.85 kg-m, 74 in-lb)
5) Install new O-ring and PCV valve to rocker cover (RH), if removed.
6) Install PCV hose.
^
Insert PCV hose by 25 to 30 mm (0.98 to 1.18 in) from connector end.
^
When installing, be careful not to twist or come in contact with other parts.
7) Installation of the remaining components is in the reverse order of removal.