Equator 2WD V6-4.0L (2009)
2) Install oil pan drain plug.
3) After 30 minutes fill with engine oil and inspect for leaks.
CAUTION:
Do not fill the engine with oil for at least 30 minutes after oil pan is installed.
INSPECTION AFTER INSTALLATION
1) Check engine oil level and adjust as needed.
2) Start engine, and check for leaks of engine oil.
3) Stop engine and wait for 10 minutes.
4) Check engine oil level again.
REMOVAL (Upper)
WARNING:
To avoid the danger of being scalded, do not drain engine oil when engine is hot.
CAUTION:
^
Perform this procedure when engine is cold.
^
Do not spill engine oil on drive belts.
^
Do not spill engine coolant on drive belts.
1) Remove engine room cover with power tool.
2) Remove air duct and resonator assembly.
3) Drain engine oil.
4) Drain engine coolant.
5) Remove front final drive (4WD models).
6) Disconnect steering gear lower joint shaft bolt and steering gear nuts and bolts, position out of the way.
7) Remove starter motor.
