Equator 2WD V6-4.0L (2009)
Intake Manifold: Service and Repair
Intake Manifold Collector: Removal and Installation
Intake Manifold Collector: Removal and Installation
REMOVAL
1) Remove the engine undercover using power tool.
2) Remove engine room cover using power tool.
3) Remove air cleaner case (upper) and air duct and resonator assembly.
4) Remove electronic throttle control actuator as follows:
a) Drain engine coolant, or when water hoses are disconnected, attach plug to prevent engine coolant leakage.
WARNING:
To avoid the danger of being scalded, never drain engine coolant when engine is hot.
CAUTION:
^
Perform when engine is cold.
^
Do not spill engine coolant on drive belt.
b) Disconnect water hoses from electronic throttle control actuator.
^
When engine coolant is not drained from radiator, attach plug to water hoses to prevent engine coolant leakage.
c) Disconnect harness connector.
d) Loosen bolts in reverse order as shown.
CAUTION:
^
Handle carefully to avoid any shock to electronic throttle control actuator
^
Do not disassemble.
5) Remove the following parts:
^
Vacuum hose (to brake booster)