Equator 2WD V6-4.0L (2009)
Right bank: Use circle type (7) and (10).
Left bank: Use oval type (4) and (5)
^
Align dowel pin (3) and pin hole on camshafts with the groove (11) and dowel pin on sprockets, and install them.
^
On the intake side, align pin hole on the small diameter side of the camshaft front end with dowel pin (3) on the back side of camshaft
sprocket, and install them.
^
On the exhaust side, align dowel pin on camshaft front end with pin groove (11) on camshaft sprocket, and install them.
^
In case that positions of each mating mark and each dowel pin do not fit on mating parts, make fine adjustment to the position holding the
hexagonal portion on camshaft with wrench or equivalent.
^
Bolts for camshaft sprockets must be tightened in the next step. Tightening them by hand is enough to prevent the dislocation of dowel
pins.
^
It may be difficult to visually check the dislocation of mating marks during and after installation. To make the matching easier, make a
mating mark on the top of sprocket teeth and its extended line in advance with paint.
c) After confirming the mating marks are aligned, tighten camshaft sprocket bolts.
