Equator 2WD V6-4.0L (2009)
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor
Side Air Bag (Satellite) Sensor: Removal And Installation
REMOVAL
CAUTION:
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
2. Remove front door sill finisher and lift carpet.
3. Remove side air bag (satellite) sensor nuts and release the clip.
4. Disconnect the side air bag (satellite) sensor connector.
CAUTION:
-
Do not use old nuts after removal; replace with new nuts.
-
Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace
it with new one.
-
Do not disassemble side air bag (satellite) sensor.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
Installation is in the reverse order of removal.
-
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to [SRS Operation Check].
