Equator 2WD V6-4.0L (2009)
REAR (M226)
Removal
1) Remove the axle shaft assembly.
2) Pull the sensor rotor off of the axle shaft using Tool and a suitable press.
Tool number: ST30031000 ( - )
Installation
1) Install the new sensor rotor on the axle shaft using a suitable length steel tube and a press. Make sure the sensor rotor is fully seated.
CAUTION:
Do not reuse the old sensor rotor.
2) Install the axle shaft assembly.
CAUTION:
Do not reuse the axle oil seal. The axle oil seal must be replaced every time the axle shaft assembly is removed from the axle shaft
housing.