Equator 2WD V6-4.0L (2009)
Yaw Rate Sensor: Service and Repair
G Sensor: Removal and Installation
REMOVAL
1) Remove center console.
2) Remove yaw rate/side/decel G sensor attaching nuts as shown.
^
The location of the sensor is the same for all models.
CAUTION:
^
Do not use power tools to remove or install yaw rate/side/decel G sensor.
^
Do not drop or strike the yaw rate/side/decel G sensor.
3) Disconnect harness connector and remove the yaw rate/side/decel G sensor.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
After performing the above work, calibrate the yaw decel G sensor.
