Equator 2WD V6-4.0L (2009)
Refrigerant Pressure Sensor / Switch: Service and Repair
Refrigerant Pressure Sensor: Removal and Installation
REMOVAL
1. Discharge the refrigerant. Refer to [HFC-134a (R-134a) Service Procedure].
2. Disconnect the refrigerant pressure sensor harness connector and remove the refrigerant pressure sensor from the condenser.
CAUTION: Be careful not to damage the condenser fins.
INSTALLATION
Installation is in the reverse order of removal. Refer to [Refrigeration System: Component].
CAUTION:
-
Be careful not to damage the condenser fins.
-
Replace the O-ring of the refrigerant pressure sensor with a new one, then apply compressor oil to it for installation.
-
After charging refrigerant, check for leaks.
