Equator 2WD V6-4.0L (2009)
CAUTION:
When installing the components with rubber bushings, the final tightening of the nuts and bolts must be done with the vehicle in an unladen
condition (the fuel, engine coolant, and engine oil full; the spare tire, jack, hand tools and mats in their designated positions) with the tires on
the ground.
REMOVAL
1) Support the rear final drive assembly with a suitable jack to relieve the tension from the rear leaf spring.
^
The axle weight should be supported, but there should be no compression in the rear leaf spring.
2) Remove the shock absorber lower nut and bolt using power tool.
3) Remove the four rear spring clip U-bolt nuts using power tool, then remove the rear spring pad.