Equator 2WD V6-4.0L (2009)
Clutch Pedal Assembly: Service and Repair
Clutch Pedal: Removal and Installation
REMOVAL
1) Remove the clutch pedal bracket nuts from inside the engine compartment.
2) Disconnect the clutch interlock switch and ASCD clutch switch, then remove the wiring harness from the pedal assembly.
3) Remove the snap pin and clevis pin.
4) Remove the pedal bracket bolt and then remove the clutch pedal assembly.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
Tighten the pedal stopper bolt lock nut or ASCD clutch switch lock nut to the specified torque after installing the clutch pedal assembly in the vehicle
and adjusting the pedal free play.