Equator 2WD V6-4.0L (2009)
CAUTION:
Before removing the rear axle, disconnect the ABS wheel sensor from the assembly Then move it away from the axle. Failure to do so may
result in damage to the sensor wires and the sensor becoming inoperative.
^
Wheel bearing does not require maintenance.
^
If growling noise is emitted from wheel bearing during operation, replace wheel bearing assembly.
^
If the wheel bearing assembly is removed, it must be replaced. The old assembly must not be re-used.
REMOVAL
1) Remove the ABS wheel sensor from the axle case and reposition out of the way.
2) Remove the rear brake caliper assembly without disconnecting the brake hose and reposition out of the way.
3) Remove the parking brake assembly from the back plate and torque member.
4) Remove the axle bearing nuts securing the axle shaft assembly to the axle case.
5) Draw the axle shaft assembly out of the axle case using Tools as shown.
Tool number
A: KV40101000 (J-25604-01)
B: ST36230000 (J-25840-A)
6) Remove the O-ring.
7) Remove the axle oil seal using Tools as shown.
