Equator 2WD V6-4.0L (2009)
Tool number: KV40106500 (J-45073)
NOTE:
Always replace the bearing ring retainer with a new one.
11) Remove the back plate and torque member with the axle bearing attached from the axle shaft using a suitable press.
12) Remove the axle bearing studs to release the axle bearing from the back plate and torque member using a suitable hammer or press.
13) Remove the wheel studs using a suitable hammer or press.
14) Remove the grease catcher from the axle shaft.
INSPECTION AFTER REMOVAL
Axle Shaft
^
Check axle shaft for straightness, cracks, damage, wear and distortion. Replace if necessary.
Axle Case
^
Check axle case for yield, deformation and cracks. Replace if necessary.
INSTALLATION
1) Install the grease catcher on the axle shaft.
2) Install the wheel studs through the grease catcher into the axle shaft using a suitable press.
NOTE:
All six wheel studs must be pressed on at the same time and are flush with the grease catcher when installed.
3) Position the axle bearing on the back plate and torque member.
4) Install the axle bearing studs using a suitable press to attach the axle bearing to the back plate and torque member.
NOTE:
