Equator 2WD V6-4.0L (2009)
CAUTION:
When inserting axle shaft, be careful not to damage oil seal.
NOTE:
The split ends of the Tool must butt up together and not overlap as shown.
Tool number: - (J-34296-1 part of J-46215)
17) Insert the axle shaft assembly. Tighten the axle shaft nuts evenly in a criss-cross pattern to specification.
^
Remove the Tool when the axle shaft assembly is approximately 90% inserted to protect the new axle oil seal.
Tool number: - (J-34296-1 part of J-46215)
18) Install the parking brake assembly on the back plate and torque member.
19) Install the rear brake caliper assembly.
20) Install the ABS wheel sensor into the axle case.
